Pipe lagging in Exeter
Professional pipe lagging services in Exeter and surrounding areas. Local, reliable handyman - no job too small.
Price Guide
£60-85
Typical Duration
1-1.5 hrs
Location
Exeter, Devon
Pipe lagging fitted to exposed pipework in lofts, garages, and outbuildings. Quick job that protects against freezing and saves heat loss - sensible prevention before winter hits.
Don't Wait Until Pipes Freeze
Ever had a burst pipe? It's expensive, disruptive, and completely avoidable. One night of hard frost and those exposed loft pipes can freeze solid - then when they thaw, you've got water pouring through your ceiling.
💡 Pro tip: Most burst pipes happen when the weather warms up after a freeze, not during the cold itself. The ice melts, cracks appear, and suddenly you're dealing with a flood.
Why Lagging Matters
| ✅ Done Right | ❌ Left Bare |
|---|---|
| Pipes insulated with proper foam lagging | Exposed copper pipes in cold loft |
| Protected from freezing temperatures | Vulnerable to hard frost |
| Hot water stays hot longer | Heat lost before water reaches taps |
| Peace of mind through winter | Fingers crossed and hoping |
What You Get
🔧 The Full Service
| Stage | What Happens |
|---|---|
| Check | Assess which pipes need protection |
| Fit | Foam lagging fitted to all exposed pipework |
| Seal | Joints and fittings properly covered |
📦 You're Left With
- All vulnerable pipes fully insulated
- Protection against freezing weather
- Reduced heat loss on hot pipes
- Job done properly before winter
Pricing Guide
| Pipework Amount | Estimated Time | You'll Pay |
|---|---|---|
| Few problem areas | 1 hr | £60 |
| Average loft | 1-1.5 hrs | £60-£85 |
| Large loft or outbuilding | 1.5-2 hrs | £85-£110 |
Based on £60 minimum (first hour) + £50/hr after. Final quote depends on length of pipework and access.
Perfect For Your Property If...
✅ Exposed loft pipes - most common place for freezing problems
✅ Garage plumbing - taps and pipes in unheated spaces
✅ Long hot water runs - kitchen miles from boiler
✅ Old outbuildings - exposed pipework in cold spaces
Why Choose Us for Pipe lagging in Exeter?
Prevents pipes freezing in cold weather
Reduces heat loss from hot water pipes
Quick job - usually done in an hour
Can save money on heating bills
What to Expect
Step 1: Check What's Needed
I'll look at all your exposed pipework and work out what needs lagging. Sometimes there's bits already done, sometimes it's all bare.
Step 2: Fit the Lagging
Foam pipe insulation cut to length and fitted over each pipe. Joints and fittings get covered properly - that's where heat escapes fastest.
Step 3: Sort Any Awkward Bits
Odd-shaped sections, tight corners, pipe clusters - they all get lagged properly. No point leaving vulnerable spots exposed.
🔧 DIY Tips
Want to have a go yourself? Here's how to get good results:
🔧 Tools you'll need
- Foam pipe lagging (right diameter for your pipes)
- Stanley knife or scissors
- Cable ties or lagging tape
- Measuring tape
📏 Measuring pipe diameter Most domestic pipes are 15mm or 22mm. Measure the outside diameter to get the right size lagging - too loose won't work properly.
✂️ Fitting technique
- Cut lagging to length with sharp knife
- Open the slit along one side
- Push pipe into the foam sleeve
- Seal the slit with tape or ties
- Overlap joints by a few centimetres
⚠️ Common DIY mistakes
- Leaving gaps at fittings and joints
- Using wrong diameter - too loose is useless
- Not lagging the cold water pipes (they freeze too!)
- Forgetting pipes in harder-to-reach areas
💡 Pro trick: On hot pipes, insulate the WHOLE run from boiler to where it's used. Even 2 metres of bare pipe loses heat you've paid to create.
Rather leave it to a pro? No problem - that's what I'm here for. Give me a call.
Good to Know
🎨 Winter prep? Get this done in autumn before the cold hits. Frozen pipes always happen at the worst possible time - usually when you're away or it's a bank holiday.
Got a lot of pipes? Bundle it with other loft jobs - boarding, insulation, light fitting. I'm already up there with the ladder out.
Old house with dodgy loft access? No problem. I've been in Exeter attics that haven't been accessed in decades. That's where the worst unprotected pipes usually are.
Frequently Asked Questions
Why do I need pipe lagging?
Two main reasons: stops your pipes freezing (and bursting) in winter, and keeps hot water hot for longer if it's travelling a distance from your boiler. In Exeter's older properties with exposed pipes in lofts or outbuildings, it's actually pretty important.
Can you do the pipes in my loft?
Yes - that's exactly where most people need it done. Loft spaces get freezing in winter, and those exposed pipes are vulnerable. I'll lag everything that needs protecting - hot, cold, and central heating pipes.
Do I need to provide the lagging material?
Either way works. I can bring everything needed, or if you've already bought specific insulation, I'll fit what you've got. Standard foam pipe lagging is usually fine for most jobs.
How long does it take?
Typical loft with exposed pipes is usually 1-1.5 hours. More if there's loads of pipework, less if it's just a few problem areas. I'll give you a time estimate when I see what you've got.
Will this definitely stop my pipes freezing?
Lagging massively reduces the risk - slows heat loss so pipes stay warmer for longer. In extreme cold snaps you might still need to leave heating on low, but properly lagged pipes are far less likely to freeze and burst.
Pipe lagging Also Available In:
Get a Free Quote in Exeter
Call us today for a free, no-obligation quote for your pipe lagging job in Exeter.
01392 964094Request Online QuoteOur Rates
Got multiple jobs?
Make the most of your first hour - I can often tackle several small tasks in one visit. List everything you need done when you call!
Why Trust Us
Need Pipe lagging in Exeter?
Get a free quote for your pipe lagging job in Exeter today.